Description

Our billet 52mm Gauge Holder is designed to install any 52mm Gauge, such as the Haltech CAN Gauge shown in the photos, without cutting or drilling holes in the interior panels.

A minor hole must be cut in the AC piping to permit access for power/data via CAN to supply to the gauge; otherwise, the gauge holder provides a seamless installation that can easily be reverted to stock.

However, the gauge holder provides a seamless installation that could be effortlessly reverted to stock.

Note: Whilst there is a vent around the gauge, air will not pass through this vent once the holder has been installed.

Finish

• Machined from Billet 6061 Aluminium - Black Anodised.

Included

• 1x JZA80 52mm Gauge Billet Gauge Holder

Installation Instructions

1. Remove dash panels to gain access, the upper, middle and shifter panels are required to be removed to gain access to the main panel.

2. Carefully unclip the OEM AC Vent from the dash panel.

3. Align the Billet Holder with the clips on the dash panel, rotate until all 3 clips align.

4. Install Gauge and wire in as required

5. Reinstall Dash Panels in reverse order.